Thingiverse
Arrma Shock sleeve
door Printerman100
1
Downloads
2
Likes
0
Makes
Print with TPU
I used to convert a Mojave to a street Mojave using original shocks. Just used Limitless springs in rear. Buggy tires.
Adjust length on z-axis in slicer if you want to use Typhon 6s springs in front (about 2cm shorter).
Print in TPU, 80% infill, 4 perimeters. 4 top and 4 bottom.
You just as well might use this part on a Typhon and use Limitless springs if you want the suspension to be more tight.
I used to convert a Mojave to a street Mojave using original shocks. Just used Limitless springs in rear. Buggy tires.
Adjust length on z-axis in slicer if you want to use Typhon 6s springs in front (about 2cm shorter).
Print in TPU, 80% infill, 4 perimeters. 4 top and 4 bottom.
You just as well might use this part on a Typhon and use Limitless springs if you want the suspension to be more tight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!