Thingiverse
Arrma Spring Spacers
door TheFuzz1542
59
Downloads
44
Likes
0
Makes
After breaking the aftermarket front shocks to my Arrma Senton BLX 3S while bashing with some friends I had to quickly swap out the shocks with the originals. Problem was I couldn't find the spacers anywhere for them so I had a "saggy" front end that caused the front skid plate to constantly bottom out. I drew these up when I got home so I wouldn't have to buy / wait for new spacers directly from Arrma.
I made 5mm & 7mm thick spacers but if you want a different thickness you could simply resize the "Z" axis on the 5mm spacer with your slicer program however I never used one thinner than 5mm so I cant say how strong that would be. I assume that you could probably get it down to 3mm just fine but again, I haven't done this yet. I used PLA with 100% infill and these feel a lot like the originals when putting them on or taking them off and I have done so many times without any breaking. I made them a little thicker in the mid height section for strength.
These would probably work on
I made 5mm & 7mm thick spacers but if you want a different thickness you could simply resize the "Z" axis on the 5mm spacer with your slicer program however I never used one thinner than 5mm so I cant say how strong that would be. I assume that you could probably get it down to 3mm just fine but again, I haven't done this yet. I used PLA with 100% infill and these feel a lot like the originals when putting them on or taking them off and I have done so many times without any breaking. I made them a little thicker in the mid height section for strength.
These would probably work on
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
