Artemis Styled Patch - NO AMS

I am a self-proclaimed space geek and all that entails! I have been following the Artemis missions since they began and couldn't help myself to see what I could do to make a model out of the original Artemis Program Patch. I wanted to create both a magnetized version and a bit of a wider, stand-alone version so it could be displayed on a desk, shelf, etc.

For the magnet version, I attempted several times to embed the magnets approximately .5 mm deep, however, was finding even with four magnets, it was slipping off of surfaces. After some reading, my conclusion is the heat from the print was doing some form of demagnetization. I decided after several failures to make the magnets visible. Not sure if it is just the brand of magnet I used in the project, but it was better to leave the magnets exposed for this project.

I am including all individual .stl files, if the slicer .3mf files are requested, I will be happy to add them as well.

Dimensions: ~123 mm tall, ~116 mm long, 10 mm