Thingiverse
Articulated Hippo
von stroibe974
32
Downloads
27
Likes
1
Makes
Articulated Hippo (v. 1.1)
The first edition (unpublished) was a fail, at least on my printer, probably because the empty spaces between the parts were too narrow... and because my printer is certainly not properly calibrated yet.
This new version is a success and should work even if you are new to 3D printing.
This model includes a new hinge design which I created following the Hinge Design recommendations on https://www.thingiverse.com/thing:2738211
This new hinge works well on thinner prints (~ 5mm instead of ~10mm).
The first edition (unpublished) was a fail, at least on my printer, probably because the empty spaces between the parts were too narrow... and because my printer is certainly not properly calibrated yet.
This new version is a success and should work even if you are new to 3D printing.
This model includes a new hinge design which I created following the Hinge Design recommendations on https://www.thingiverse.com/thing:2738211
This new hinge works well on thinner prints (~ 5mm instead of ~10mm).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!