Articulated Jumping Spider Keychain Version

This model has been altered to have a large thick key-ring loop so that it can be made into a key-chain. The original also has a butt loop but it is much smaller and thinner. 

Suggested scale for printing is 65%-80%.

I was able to print the model at 50% scale but did notice a spot between the first two legs that slightly stuck. Printing at this size or smaller may be difficult. I suggest slowing down your print speed if you attempt to print small.

*I printed my models on an Ender 3 V3 SE. Results may differ on other printers.

Suggested settings for BODY:
Support: NO
Brim: YES
First layer slowed to 30mm/s

Suggested settings for EYES:
Support: NO
Brim: NO
All layers slowed to 20-30mm/s (the smaller the scale, the slower you need to go, and make sure bed is squeaky clean!)

*It may not be possible for some printers to print eyes for models below 65% scale. I suggest only printing the “no-eyes” model for sizes 75% and higher.

This model is 100% my own creatio