Asalato

**This is inspired from tomohiroinoue because I had strange issues with the files. (bad size for the modes without support). So I remade it so that I can print easily.**

Use Support for the asalato bottom, but set the "Support Overhang Angle" = 85 (in Cura).
So that the support is only used for the exterior overhang, and not on the Dome.

I recommend printing at 0.15 mm with Adaptative Layers (in Cura)

Asalato top is printed without support.

I recommend infill = 100% because it is a better sound quality and better resistance.

For the assembly, i used:
- > simple rope (diameter 3.5 mm)
- > fill the asalatos with some rice.
- > glue the 2 parts

Enjoy !