Ascent 18 - Tracks

Tracks for the OG Redcat Ascent 18. These tracks WILL NOT fit the Ascent 18 brushless high steer trucks. The brushless trucks have different steering geometry. Check out my MakerWorld profile for tracks that fit the brushless high steer Ascent 18 and the Ascent 32!Boost MeWant more free STLs like this? Consider boosting me!Required Hardware(8) - 12mm x 18mm x 4mm bearings(16) - 4mm x 9mm x 4mm bearings(32) - M2 x 8mm screws The idler wheels have a pause command at layer 38. When the printer pauses, drop the 4mm x 9mm x 4mm bearings into the cavities and then resume printing. The bearings will be locked in place. Press the 12mm x 18mm x 4mm bearings into the inner and outer frames. The inner frames are marked with LF and RF to distinguish left front and right front. The rear inner frames are the same and can be used on either side. Install the idler support shafts with four M2 x 8mm screws. Install the idler wheels and spacers.<img class="image_resized" style="width: 41.42%" src="https: