ASH - Awesome Spool Holder

###Why use ASH?

it lets you use big spools without breaking your chinesium printer.

Why not TUSH? - i just thought it was gay that it *had* to be glued together. it takes a bit longer to print but it has a compliant clip thing so any epoxy is optional and used only for stronger attachment, i still recommend it for big spools, put jb weld in the ridge at the bottom or something. (that's why it's there)



###V2 UPDATE

The wheel is an upgrade for old "V1" ASH prints (though i recommend it regardless). V2 deals with spools sticking because of manufacturing issues by adding a beveled edge, so the spool gets pushed back into the rail while keeping it one symmetrical part.



#####▼ bearing guide ▼

requires four (4) #608 ball bearings. [available here](https://www.amazon.com/dp/B07216D1SZ)

1. clean with water
2. displace with wd40
3. lubricate with nuG oil, chain grease, or similar