Askar SQA55 Front Stabilizer

I designed this to stop the scope from flexing once it's weighted with a guide scope, mini PC etc. You will need the following to complete this

3 x M5 Thumb Screws (I reused some from a guide scope that had rubber bumpers on the ends. You could also use Nylon screws to keep from scratching the scope)

1 M6 x 25 Bolt/Screw which

M5 and M6 Tap.

Print the item, then tap the 3 holes in the ring with the M5 tap, and the hole in the bottom with the M6.

I printed this with ASA, but it could be printed with any rigid filament.