Thingiverse
Astro Pi
von Furf
43
Downloads
25
Likes
2
Makes
Must use rafts! The thick printing causes warpage without the raft.
All information provided by
https://www.raspberrypi.org/learning/3d-printed-astro-pi-flight-case/
I reinforced the button holes with lightweight aluminum sheet on both sides.
Couldn't get the joystick button to fasten but it's not entirely required. I used clear coat after I applied labels. Using the Raspberry Pi 3 with built in Bluetooth and Wifi freed up the USB's
All information provided by
https://www.raspberrypi.org/learning/3d-printed-astro-pi-flight-case/
I reinforced the button holes with lightweight aluminum sheet on both sides.
Couldn't get the joystick button to fasten but it's not entirely required. I used clear coat after I applied labels. Using the Raspberry Pi 3 with built in Bluetooth and Wifi freed up the USB's
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
