Astromech N-3d0 Customizable Droid

Astromech N-3d0 Customizable DroidAll models are printable without any supports, an AMS is optional but you will need to add manual filament changes to some of the parts Parts list:1x Droid-Head1x Droid-Body1x Droid-Base1x Neck-Ring-- Connecting Pins - 1x 10x19mm | 1x 10x22mm | 1x 5x12mm | 1x 5x9mm2x Droid-Leg2x Droid-Leg-Foot-- Connecting Pins - 4x 5x9mm2x Shoulder-Panel2x Shoulder-Pin~27x PanelsThe connecting pins are printed with a flat side because they print much smoother and stronger this way There are 8x panel slots in Droid-Head, 16x in Droid-Body, 1x in Droid-Base and 1x in each Droid-Leg I have printed a lot of panels to dial in the size but this may differ for every printer and filament. They should easily pop into the slots and hold them self in place, if they fall out to easily you may want to use a little glue to hold them permanently, If they are to tight then I would recommend calibrating your printer and chosen filament. You could reduce or increase the x and y size of