Slicer Discord
Astromech Power Coupler Overlays – 3D-printbaar model van Thingiverse Thingiverse

Astromech Power Coupler Overlays

door TeamTEOR
27 Downloads
17 Likes
0 Makes
Model downloaden
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/iGXZheqJ6xX

Fold a length of clear or masking tape into a loop to make it like double sided tape. Place your parts onto of the tape and then apply it to a sheet of paper, or a box. Take this outside and lightly spray a layer or two of primer onto the parts. Wait till the primer dries, then apply your paint color of choice. Once that is dry remove the parts from the tape. If there is extra paint that comes off with the part clean it up by placing the part on top of cardboard and use a disposable box cutter to trim it off by running the blade along the edge of the part. It will leave you with a super clean edge. For the circle, run a piece of rolled up sandpaper in the center to clean that area up if needed. ENJOY!!!!
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Schilderen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie