Thingiverse
ASUS power supply mount
von cs301
3
Downloads
2
Likes
0
Makes
The separate power supply for the monitor bothered me, so I made a screw-on mount for it. (16x3.5 mm screws)
It is for the 65W power supply, where the angled plug comes out a little further at the edge. There is an extra flattening in the bracket for this.
The power supply unit was already in the holder, so it's quite easy to put in and take out again. However, the monitor was sent back because I wasn't satisfied with the quality.
Maybe someone needs a mount like this.
Use flexible and temperature-resistant material for it, PETG should be enough.
It is for the 65W power supply, where the angled plug comes out a little further at the edge. There is an extra flattening in the bracket for this.
The power supply unit was already in the holder, so it's quite easy to put in and take out again. However, the monitor was sent back because I wasn't satisfied with the quality.
Maybe someone needs a mount like this.
Use flexible and temperature-resistant material for it, PETG should be enough.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!