Thingiverse
AT-AT Cannons
von awroberts
5
Downloads
3
Likes
0
Makes
As I`m a clumsy, heavy handed oaf, I snapped the cannons off my AT-AT head (https://www.thingiverse.com/thing:3277951) within 5 mins of the print finishing.
Rather than print another whole head I created this instead.
Just drill the head cannon holes out with a 5mm drill to a depth of at least 35mm and these should slide right into place.
Print them flat to your bed to give them strength.
Credit to McAnultyMiniatures for the full model: https://www.thingiverse.com/thing:3277951
Rather than print another whole head I created this instead.
Just drill the head cannon holes out with a 5mm drill to a depth of at least 35mm and these should slide right into place.
Print them flat to your bed to give them strength.
Credit to McAnultyMiniatures for the full model: https://www.thingiverse.com/thing:3277951
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
