Thingiverse
Atari 2600/VCS cartiridge receiver
door RabbitEngineering
62
Downloads
50
Likes
1
Makes
If for some weird reason you want to build a thing that accepts Atari 2600 / VCS cartridges, then you will need this thing - it's what pushes open the little dust door on the carts and exposed the card edge connector.
It's designed to accept a 24 pin card edge connector in the middle. Push the connector into the front of vcsslot.stl, and then secure it by screwing strap.stl behind it. The strap attaches using M3 screws (you will need to tap out the holes, or just glue it in place if you prefer).
Print with supports.
It's designed to accept a 24 pin card edge connector in the middle. Push the connector into the front of vcsslot.stl, and then secure it by screwing strap.stl behind it. The strap attaches using M3 screws (you will need to tap out the holes, or just glue it in place if you prefer).
Print with supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!