Atari 5200 Controller Bezel - Start/Pause/Reset

Preliminary model for testing on a replacement for the Atari 5200 controller. This bezel covers the Start - Pause-Reset buttons and holds them in place.

This model is based on and measured from the actual piece and may need tweaking to fit, so it's currently a WIP.

Notes:
-The triangular shaped "clips" on the sides that snap this in place may need to be redesigned as round due to the nature of resin being not quite as strong as the original plastic.

-Rounding all the square corners slightly will probably need to happen to ease in the installation.

3D printing settings
None yet. modeled for resin printing. It'll probably print pretty well flat on the buildplate. I'll give it a shot in different orientations this weekend for resin printing.

Recommend printing FDM in the Face Down position (as downloaded) with small supports under the triangular side clips.