Thingiverse
Atari CX-10 Joystick Button Alignment Jig
von MacGyverr
0
Downloads
0
Likes
0
Makes
# Atari CX-10 Joystick Button Alignment Jig
After countless tries at aligning the new domes for my vintage Atari joysticks I gave up on eyeballing them and designed this simple two-piece jig. It lines up all five triangle-dome buttons the same every time and helps align them on the original circuit board.
Hopefully it helps someone.
---
## What’s Included
- **Normal jig**
Holds the five 10 mm triangle-dome contacts for initial placement.
- **Mount jig**
Aligns both the taped-up domes and the CX-10 PCB.
- **Bonus jigs (optional backups)**
Two extra resized jigs in case your buttons are slightly out of spec.
---
## You’ll Need
- **5 × 10 mm triangle-dome buttons** (no legs)
I originally grabbed mine on AliExpress at $4 for 100:
https://www.aliexpress.us/item/3256802037736386.html
_(Be sure they’re 10 mm, no leg. This new link is about $8 for 200.)_
- **Clear packing tape** (cut into ~5 in / 12 cm strips)
- **Goo-Off or acetone** (to remove old tape glue
After countless tries at aligning the new domes for my vintage Atari joysticks I gave up on eyeballing them and designed this simple two-piece jig. It lines up all five triangle-dome buttons the same every time and helps align them on the original circuit board.
Hopefully it helps someone.
---
## What’s Included
- **Normal jig**
Holds the five 10 mm triangle-dome contacts for initial placement.
- **Mount jig**
Aligns both the taped-up domes and the CX-10 PCB.
- **Bonus jigs (optional backups)**
Two extra resized jigs in case your buttons are slightly out of spec.
---
## You’ll Need
- **5 × 10 mm triangle-dome buttons** (no legs)
I originally grabbed mine on AliExpress at $4 for 100:
https://www.aliexpress.us/item/3256802037736386.html
_(Be sure they’re 10 mm, no leg. This new link is about $8 for 200.)_
- **Clear packing tape** (cut into ~5 in / 12 cm strips)
- **Goo-Off or acetone** (to remove old tape glue
MacGyverr veröffentlicht auch auf
32 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!