Atari ST Gotek bracket for big button disk drive

This model is basically some minor tweaks to Wilseyed's design here: https://www.thingiverse.com/thing:5882098
- I enlarged the OLED area to use the OLED from Lonely Binary: https://lonelybinary.com/collections/display/products/geekcreit-0-91-inch-128x32-iic-i2c-blue-oled-lcd-display-diy-oled-module-ssd1306-driver-ic-dc-3-3v-5v-for-pic?variant=43926997565597
- Added bracing to the upright screw mounts on the frame
- Added hole for a 5mm x 2mm LED
- Removed the hole for (I'm assuming) the rotary encoder as it's something I didnt want on mine.

TIPS:
- I was able to print the face on my K1C without support and only had a couple of stray strands of filament that were easily cleaned up
- For the OLED, solder the wires directly to the OLED board and trim the solder side as dead flush as you can (ie: done use pin headers)
- Also for the OLED, the thin flap does help position the screen, but a piece of tape to hold it all in place securely is needed.
- With the LED you can either:
-