Atari ST Gotek Mount Rotary Encoder

Edit of BRAINCELL's Oled gotek mount to accept KY-040 rotary encoder with 7mm diameter, even without thread.
Note: You might have to solder to move the rotary encoder header pins.
Note: Not compatible with slanted floppy slot.

**How to place the gotek mount in the atari:**
1. Attach gotek board (upside down) to printed mount.
2. Attach oled and rotary encoder. And attach the brass standoff in the right hole on the printed mount making sure it stays in place.
3. Place gotek in Atari and attach floppy cables (do not screw in the floppy screws yet).
4. Place Atari top cover on, push the rotary shaft back and through the floppy slit.
5. Use the rotary shaft to guide the brass standoff in place, as soon as it's in place the rest of the cover will fall in place as well.
6. Turn the Atari upside down making sure everything stays in place.
7. First attach the case screws and then the three floppy screws (you might have to use longer floppy screws M3x30 as opposed to original M3x25).

**!!! -