Thingiverse
ATI straton lamp holder
door Muhkuhx
2
Downloads
1
Likes
0
Makes
holder for hanging a ATI straton reef light on a aluminium T-profile for hanging multiple lamps on one rail.
best printed flat on its side, so no supports needed.
It is a tight fir to slide onto the aluminium profile, end then to get the holder under the cable.
The first time it can be quite hard to get the cable over the block into the gap.
The "wings" prevent the lamp from wobbeling too much and in case of slipping, prevent the lamp from turning more then a couple of degrees. So the lamp can not touch the water by slipping off the cable.
best printed flat on its side, so no supports needed.
It is a tight fir to slide onto the aluminium profile, end then to get the holder under the cable.
The first time it can be quite hard to get the cable over the block into the gap.
The "wings" prevent the lamp from wobbeling too much and in case of slipping, prevent the lamp from turning more then a couple of degrees. So the lamp can not touch the water by slipping off the cable.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
