Thingiverse
Atom Echo Voice Assistant Base
by jmtodaro
7
Downloads
4
Likes
0
Makes
A minimalist base for the [m5stack Atom Echo](https://shop.m5stack.com/products/atom-echo-smart-speaker-dev-kit). This was created to keep the Echo a bit more stationary for [voice assistant](https://www.home-assistant.io/voice_control/thirteen-usd-voice-remote/) use.
**Important:** Make sure "Print Thin Walls" *(or your slicing software's equivalent)* is enabled.
Print with higher infill for added weight, and it is highly recommended to add non-slip pads to the bottom. The pads alone work well enough for my use case at 10%*(!)* infill.
I print this face down (with supports on the inner recessed lip only) for a better top finish. The little notches do not need support.
**Important:** Make sure "Print Thin Walls" *(or your slicing software's equivalent)* is enabled.
Print with higher infill for added weight, and it is highly recommended to add non-slip pads to the bottom. The pads alone work well enough for my use case at 10%*(!)* infill.
I print this face down (with supports on the inner recessed lip only) for a better top finish. The little notches do not need support.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
