Atomic Pi - Simple low profile case

Simple case for the "Atomic Pi" single board computer.

Because of the official model totally doesn't fit with the stupidly placed bottom power connector, i created this one.

You may add bevels and extra holes for electrical access to GPIOs etc. This version is simple and just for computing.

Power connector inside:
There's enough space left on the bottom for the power connector.
You may use bent Dupont jumper cables.
Wires have space on the side next to the sbc to reach the top area.
On my version i soldered wires directly on top.

Power connector outside:
5mm diameter hole for some power socket.

HDMI-Hole:
It has a bigger cut because some HDMI connectors may be bigger.

CMOS-Reset:
I already had to perform a cmos reset after no external EFI files could be found and booted. So you can reach it with a spiky tool.

SD card:
It's underneath to not accidently eject it. May be ejected with a tool or a longer nail.

Heat sink:
Until temperatures seem not to get to