Thingiverse
AtomX MK3
door CuriousTimo
23
Downloads
18
Likes
0
Makes
Here are some parts that I remixed and used for my AtomX MK3 build.
The extruder is a remix of the Prusa MK3 but with the Direct Drive chopped off.
It also has a sensor for Auto Bed Leveling
My AtomX is mounted to an IKEA bamboo chopping board for stability.
I also cheated and widened the X-Carriage and printed the bed as a One-Piece.
The bed is an Aliexpress 120*120mm 12V R207, but I still need to figure out how to connect it. It has 5 wires.
- -Heat and 12v is the heating I guess
- C16, 5v, GND the thermistor. (No clue how to connect this)
The RAMPS box is https://www.thingiverse.com/thing:1758859
All other parts are from Cliff Mellangårds original AtomX https://www.thingiverse.com/thing:1444061
The extruder is a remix of the Prusa MK3 but with the Direct Drive chopped off.
It also has a sensor for Auto Bed Leveling
My AtomX is mounted to an IKEA bamboo chopping board for stability.
I also cheated and widened the X-Carriage and printed the bed as a One-Piece.
The bed is an Aliexpress 120*120mm 12V R207, but I still need to figure out how to connect it. It has 5 wires.
- -Heat and 12v is the heating I guess
- C16, 5v, GND the thermistor. (No clue how to connect this)
The RAMPS box is https://www.thingiverse.com/thing:1758859
All other parts are from Cliff Mellangårds original AtomX https://www.thingiverse.com/thing:1444061
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!