Thingiverse
ATST - 1:75 - Easyprint
di Heref
908
Download
467
Likes
7
Makes
This is a AT-ST model in 1:75. It prints in two parts. Just remove the supports and snap them together. Then you can rotate the head making pew pew sounds as you run down pesky Ewoks!
At 1:75 it is about the same height as the AT-ST included in Imperial Assault.
It goes along well with Kirby Downy's excellent AT-AT (the leg of which is shown in the right of the picture) at myminifactory https://www.myminifactory.com/object/3d-print-detailed-at-at-17606
For simple support cleanup, print the Easyprint head as shown to the left of the walker leg. However, if you want some more and finer details, print the Harderprint head with the bottom of the neck resting on the build plate (as shown on to the right of the walker leg), but be prepared for more challenging support cleanup, especially around the left gun pod.
The legs are still pretty thin, be careful when removing the supports!
Designed and printed on the M3D Promega.
4/10/2020 - cleaned us some issues in the Head.
At 1:75 it is about the same height as the AT-ST included in Imperial Assault.
It goes along well with Kirby Downy's excellent AT-AT (the leg of which is shown in the right of the picture) at myminifactory https://www.myminifactory.com/object/3d-print-detailed-at-at-17606
For simple support cleanup, print the Easyprint head as shown to the left of the walker leg. However, if you want some more and finer details, print the Harderprint head with the bottom of the neck resting on the build plate (as shown on to the right of the walker leg), but be prepared for more challenging support cleanup, especially around the left gun pod.
The legs are still pretty thin, be careful when removing the supports!
Designed and printed on the M3D Promega.
4/10/2020 - cleaned us some issues in the Head.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!