Attachable ear-saver

I have tested several other earsaver models, but with all of them it bothered me that if you take the mask off and put it in your pocket, you have 2 parts. Besides, hooking it in was not so easy. So here is my new proposal. Of course I accept suggestions for improvement.
With my Ender-3, printing an earsaver takes about 30 minutes at high resolution.

There are 2 versions, one with a stronger (1.4 mm) "main strip" and the normal version with 1.2 mm. Which is a tradeoff between flexibility and durability, but from my point of view the flexibility is enough in the stronger version.

If you want to speed up the print, I found out that printing 5 wall lines instead of the standard 3 lines reduce the print time to about half.

Have fun with it :-)