ATX open frame

First, I have to give credit to lightofhonor for the concept of this design. When I read the comments on his design people were unhappy because the PSU mount did not fit. I was working on another project and did have much time to devote to a MB mount. I used his concept and started over from scratch. None of the parts will fit his model. Also, since I didn't have time to optimize some will require sanding to fit. I was able to use every test print with a little sanding. All of the joints are a tight fit by design.

The only two pieces that will need to be printed twice are MBSlat.stl and connectingRib.stl. Also, these two and MBSlat2.stl will have to printed diagonally on your printer bed.

I didn't have time to incorporate the hard drive onto the MB frame. That will be in a future update. This was a slam bam model but it turned out great.