Audeze Maxwell Configurable Strap Replacement

I tried to fix strap for my new Maxwell - it should be wider and shorter.First I tried to print this model - this model was a bit bigger than I needed and had one issue - deformation under load.So as usual - “If you want to do it well, do it yourself”By default there are TWO mirrored models on one plate - don't change the position of the models.It was done to create a ‘stiffening rib’ in the model. USE TPU ONLY!!! TPU-95a or softer. I tried to print it from harder TPU and couldn't put the strap on the headphones Important:Top/Bottom shell layers are set to 0 - this is not an error (!) - Press Slice Plate button to see how it worksI'm too lazy to make infill pattern manually, so I used a trick with Sparse Infill parameters. Size. Default Audeze strap has 232 mm between middle holes on the strap.My model has 221.2 mm between the middle holesYou may change the size by scaling the model - best way is to merge both models in one, then scale by X axis to needed size and then Spli