Slicer Discord
Audi e-tron MagSafe adapter – 3D printable model from MakerWorld MakerWorld
Electronics

Audi e-tron MagSafe adapter

51 Downloads
13 Likes
31 Makes
Go to Model
MagSafe adapter for the original Audi e-tron (the big one. not sure if it will fit the Q4 or Q6). Designed to use the original Apple MagSafe fast charger (and also fits the cheap Deltaco magsafe fast charger, which has identical dimensions). Fits the iPhone 12 (Pro), iPhone 13 (Pro), iPhone 14 (Pro) and iPhone 15 (Pro). Will not work with Max models. I added a thick felt sticker to the top surface to keep it nice and quiet (as shown in one of the photos. If you do not any any padding or your phone is smaller than the iPhone 12-15, then the charger will sit 2 mm too high, but it should still work ok. It can sit on top of the existing rubber mat or replace it. I recommend taking out the rubber mat and mounting this adapter with double sided (nano) tape so it feels sturdy and does not come off if you lift the phone straight up (as also shown in one of the photos). If you do not fasten it, you need to push the phone down and to the left when taking it out, to avoid the adapter following al
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

runesblog.com also publishes on

1 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

1 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection