Thingiverse
Aug Rail
von Michael1572
23
Downloads
30
Likes
0
Makes
This is a rail for an AUG A1 airsoft gun. Remove the front foregrip and temporarily remove the flash hider in order to slide the rail system into place.
The rail is held in place with 1 nut and bolt. The rails are 20mm Picatinny, however attachments that fit weaver rails should also fit.
I would recommend printing at 100% infill for durability. A raft and supports is also recommended. PLA+ was used in the printing of this part for strength, however any PLA should work. Print at the scale provided for correct sizing.
I have included the solid works file if you wish to modify the part.
Good Luck ! :D
The rail is held in place with 1 nut and bolt. The rails are 20mm Picatinny, however attachments that fit weaver rails should also fit.
I would recommend printing at 100% infill for durability. A raft and supports is also recommended. PLA+ was used in the printing of this part for strength, however any PLA should work. Print at the scale provided for correct sizing.
I have included the solid works file if you wish to modify the part.
Good Luck ! :D
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
