Thingiverse
Auto Bed Leveling Capacitive Sensor Mount for Sigma3D
von mgy
14
Downloads
14
Likes
0
Makes
This is the 18 mm capacitive sensor mount for Sigma3D printer for auto bed leveling.
https://www.youtube.com/watch?v=48cYu5q3wjc
I have used additional fan mounts on the X-carriage since I do not use them.
18 mm capacitive sensor.
I use Marlin Kimbra development version, added firmware as a zip file.
I can publish the firmware if needed.
You need to make a voltage divider to use the sensor.
I connected sensor to Zmin
https://www.youtube.com/watch?v=48cYu5q3wjc
I have used additional fan mounts on the X-carriage since I do not use them.
18 mm capacitive sensor.
I use Marlin Kimbra development version, added firmware as a zip file.
I can publish the firmware if needed.
You need to make a voltage divider to use the sensor.
I connected sensor to Zmin
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!