Auto Bed Leveling Sensor Mount For Anet A8

This is an improved mount for the bed leveling sensor for the Anet A8. Printing is easy, but setting up without any know how can be difficult.

====================================================================

Follow these steps to set up Auto Bed Leveling.

Z-Offset Instructions:

Home 3D printer

M851 Z0 - Reset Z0 Offset

M500 - Store settings

M501 - Set active parameters

G28 Z - Home Z Axis

G1 F60 Z0 - Move nozzle to true 0 offset

G92 Z10

Move nozzle towards bed slowly until the paper has friction

Take note of the Z on the printer display. (Take that number and subtract it from 10. Then take the result and subtract .50.) (The .50 must be subtracted because the skynet firmware automatically adds .50 to the z offset that you set.)

Home the printer

G92 Z0

M851 Z X.XX (X.XX being your z offset you calculated above)

M500 - Save settings

M501 - Set Active Parameters

Congrats! You are done!