Auto Bento Control Box for Thermal Controller

This is a Thermal Switch Setup to turn on Bento Box 2 air purifying system at a given temperature and turn off at a different temperature. The model is the box holds a XH-W3001 Thermostat Switch and has two 10mm x 5 mm cylindrical magnets to hold it to one side of your enclosed Bambulab 3D printer. Parts Used in this Setup:This makerworld model.XH-W3001 Thermostat Switch (12V)Pigtail Barrel ConnectorsAdditional 18 gauge cableSeal wire connectors10 x 5 mm cylindrical magnetsBentobox 2.0 or 1.0 (I purchased mine as a kit)Setup:See instructions for XH-W3001 for connections for 12V setupPrint my modelThe parts provided above should be all you needHow to Use:I have mine setup now at 45°C to start and 28°C to end. The idea is that when the your machine enclosure reaches a certain temperature, the bento box will start, and a while after it cools down, your air filtering stops. You could set the start temperature for example much higher, so that for example, your bento box filter only works wh