Thingiverse
Auto Music Box
por VitalSAM
10
Descargas
15
Likes
0
Makes
1x N20 Micro Speed Gear Motor 3V 120RPM
1x 12mm switch
1x AA Battery box 3V
Some musuc Boxes are not made the same so they is abit of play between the holder, to stop the music box from lifting out but some fosm double sided table on the bottom of the holder just so it sticks down but you can still lift Box out with alittle force.
The arm you might need to adjust to get it to fit onto the driveshaft
USE A RAFT for the arm and print at a slower speed.
This will print/fit on a 150mm bed
infill 20% no lower.
1x 12mm switch
1x AA Battery box 3V
Some musuc Boxes are not made the same so they is abit of play between the holder, to stop the music box from lifting out but some fosm double sided table on the bottom of the holder just so it sticks down but you can still lift Box out with alittle force.
The arm you might need to adjust to get it to fit onto the driveshaft
USE A RAFT for the arm and print at a slower speed.
This will print/fit on a 150mm bed
infill 20% no lower.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!