Auto Shutdown Kobra Go

This is a mechanism to automatically shut down the 3D printer, once the print is finished just raise the Z axis to a preset height and the lever will press the printer shutdown button.

You don't need additional screws and you don't need to modify or disassemble the printer, since I didn't have wire, I used cable ties both as a pivot for the lever and as a tie rod.

The support should snap into the metal guide, if it doesn't just print the flat thickness and insert it into the top of the support that goes into the guide.
The wire must be connected to the lever and to a hole already present on the Z axis.

You need to change the final G-code of the slicer you use.
Add to the bottom: G0 Z220 ;auto power off
(modify 220 with the height you need).

I hope you like it!