Thingiverse
Autococker Back Block v1.2
22
Downloads
15
Likes
0
Makes
Back block for a 2k+ autococker paintball marker.
I am using this for a pump setup.
Pump rod hole is slightly too small currently, will need to be drilled out. I used a 11/64 bit and drilled down about half way.
I am using this for a pump setup.
Pump rod hole is slightly too small currently, will need to be drilled out. I used a 11/64 bit and drilled down about half way.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!