Auxiliary Lights w/ Switch (No Riser)

This model adds additional interior lighting to the P1S without using a Riser as some other designs have opted for. This design utilizes the existing holes/screws on the P1S to mount two lightbars and adds an on/off button through the Racetrack-shaped hole on the top right of the printer. There are 5 screw locations. I used a USB-powered light strip (https://a.co/d/gVEXpVg) that enables us to use the existing interior USB power port on the printer. Soldering is required for the switch and possibly the light strip, but use of LED strip adhesive is not required due to the channel design of the supports. Switch used:https://a.co/d/c2sGGZh Installation of all the components can be tricky, so take your time. Here are a few tips from my experience:Install the light strip into the channels before sliding the “spine” though the rest of the partsTo install the forward lightbar assembly, you may have to pry up on the right corner of the top facia on the printer. There is also a latch you can rel