Avali Figure

This is a figure of an avali I remixed because I wanted something that wasn't T-posing. The model is hollow and I couldn't figure out how to make it solid without there being weird problems with it. There is a minimum size that it needs to be printed at or it will be missing parts like feathers or parts of the body because some walls are thin. The minimum Z-axis size must be 92mm tall.

Keep in mind that the tail may not turn out well if there are no supports on it, the tail will start moving when it gets to the end of it and cause spaghetti. What I did was hold the tail with my fingers for a bit until it was steady enough, or you can try and get supports on it.

The photo below shows what it looked like after printing and putting 3 coats of spray primer on it. The tail shows the problem I had with it moving during print, and there are small artifacts on the corners of the feathers that can be cut off. Stringing as minimal, I think most of that in the pic might be from when I spra