Thingiverse
Average Bottle Opener
5
Downloads
11
Likes
0
Makes
About: This is just my attempt at a standard coin (dime) bottle opener.
Print: YMMV In my experience this does not need to be printed with supports. This is because I created and installed my own (hella efficient) support columns where necessary. The only thing I recommend is that you make sure to print this with a minimum of a 50% infill. A 50%/+ infill should ensure that the opener is structurally sound enough to open stubborn bottles.
Print: YMMV In my experience this does not need to be printed with supports. This is because I created and installed my own (hella efficient) support columns where necessary. The only thing I recommend is that you make sure to print this with a minimum of a 50% infill. A 50%/+ infill should ensure that the opener is structurally sound enough to open stubborn bottles.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!