Aviator Sunglasses

This is a replacement frame for Rayban Aviator lenses (in case your original frame has been damaged). Filament (1.75mm) is used as pin for the hinge. You can use hot water or a heat gun (with caution) if you cannot insert the lenses. The same way you can modify the curve of the temples if you are not satisfied with the fitting.Print instructionsCategory: Glasses Print SettingsPrinter Brand: PrusaPrinter: Prusa Mk2Supports: YesNotes:For the best printing result it is advised to use PVA for support material. Otherwise, it is important to use the suggested settings below.Cura Settings (for the frame) Layer Hight : 0.1mm ( or 0.06mm) Support : Yes Support Density : 20% Support Z Distance : 0.2mm Support Horizontal Expansion : 0.5mm Enable Support Interface : Yes Support Interface Thickness : 0.4mm Support Interface Density : 100% Brim : 1mm (for the frame, if you have adhesion problems) Post-PrintingUse a piece of filament (1.75mm) as a pin.