Thingiverse
Awesome Spring Carabiner
por CruiseChef
58
Descargas
137
Likes
0
Makes
Body is best printed with PETG with a 60%-80% infill.
Spring arm must be PLA with an infill of 80-90% layer height 0.1-0.15mm.
(Cannot use PETG for spring arm. IT's too flexible)
Arm must be with PLA for a good tight snapping arm. Different PLA filaments work better for some reason. If you're not getting the tight spring return, try a different filament.
Spring arm must be PLA with an infill of 80-90% layer height 0.1-0.15mm.
(Cannot use PETG for spring arm. IT's too flexible)
Arm must be with PLA for a good tight snapping arm. Different PLA filaments work better for some reason. If you're not getting the tight spring return, try a different filament.
CruiseChef también publica en
3 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
