Slicer Discord
Awning endstop for Caravan - Ø7,8x20 M3 – 3D-printbaar model van MakerWorld MakerWorld
Vehicles

Awning endstop for Caravan - Ø7,8x20 M3

door 19JKS91 · Vehicles
10 Downloads
2 Likes
5 Makes
Model downloaden
Found out that the previous owner had destroyed the tent rail/frame rail/awning rail when I was going to replace the awning. So I printed a stopper that was a little smaller than the original, but still does the same job. Printed the hole with M3 threads. The thread is tight, but no problem when you use an Allen key when screwing in an M3 set screw. Hope this can be helpful to others too! Boost MePlease give me a boost if this was helpful to you! Thanks! :D
Categorie
Vehicles
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

2 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie