Thingiverse
Awning Gutter Clip
di joebywan
9
Download
8
Likes
0
Makes
If you're out caravanning or camping you know how rain coming off your awning turns your outside area to mush. This is put along the end of your awning to turn it into a gutter, which you can then direct the water to a bucket for use while you're on the road, while also helping top the rain digging a trench off your awning.
Should be printable without supports, I modelled it for someone who didn't want it after, so I'm putting it up here.
It's supposed to be strong, so biggest layers you can manage. I'd suggest ABS/PETG/ASA because it'll be outside, but I imagine that with PLA in the rain it shouldn't be an issue unless you leave them out until the sun starts beating down again.
Should be printable without supports, I modelled it for someone who didn't want it after, so I'm putting it up here.
It's supposed to be strong, so biggest layers you can manage. I'd suggest ABS/PETG/ASA because it'll be outside, but I imagine that with PLA in the rain it shouldn't be an issue unless you leave them out until the sun starts beating down again.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
