Thingiverse
Axe Throwing Target Stencil
von HPSilhouette
11
Downloads
7
Likes
0
Makes
This is a close approximation of the 2021 World Axe Throwing League (WATL) target stencil.
Print your own for personal use only.
Scoring ring slots are approximately 5/16 x 25/32" (8x20mm).
Print 2 halves (top and bottom) and glue together with epoxy or super glue. Overall finished length is about 61cm (24").
Recommend you sand glue tabs lightly before applying glue for maximum adhesion. Clamp until glue hardens.
Enjoy!
Print your own for personal use only.
Scoring ring slots are approximately 5/16 x 25/32" (8x20mm).
Print 2 halves (top and bottom) and glue together with epoxy or super glue. Overall finished length is about 61cm (24").
Recommend you sand glue tabs lightly before applying glue for maximum adhesion. Clamp until glue hardens.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!