Axial Capra Internal Winch

This is a remix from here https://www.thingiverse.com/thing:3134362 and here https://www.thingiverse.com/thing:3134342

I added a bearings and shortened the body of the MiniWinch. (2) 4x7x2.5mm

Video of it in action https://www.youtube.com/watch?v=0QZBXpypwE8

The axle is made from a 4mm metal rod which is forced into the 16mm gear.
I drilled a whole through the axle for rope/wire to go through.

Grill is designed to use 3d printed headlights with 5mm LED bulb in it. Grill was remixed from here https://www.thingiverse.com/thing:3990098

INSTRUCTIONS
Print off parts
install 2 bearings into outside cases
put gear on N20 motor (I used 100 RPM 6v motor it is not the fastest 200 rpm might be good balance of speed and power)
cut 4mm shaft (sorry don't know length)
drill hole in shaft for rope to attach
put gear on shaft leaving stub out to go in bearing
put shaft in case add the two small disks to keep wire in place (optional I did not use)
assemble the winch cases and s