Axle test

# axle v1:
Small part (32 minutes, 6g, 2.04m) to test the radial gap between parts as 0.5 mm
(print without support and adhesion by standard [fine - 0.2mm] settings)

1) but set the __Wall Ordering - Outside To Inside__
2) but set the __Z Seam Alignment - Shortest__

Result: The axle dangles quite freely after being removed from the table.


#axle v2:
same part as v1, but with radial gap 0.3 mm.

Result: The axle almost not dangles after being removed from the table.

>