Azeron Stand

This is a base to tilt the Azeron. I use the 30 degree version, but I've made a 20 degrees as well.

I have tendinitis on my left hand and need my peripherals to be closer to neutral position.

I'm pretty happy with that design, but it's my first.

The stand goes into the holes into the base of the azeron and stay in place as is.

Put the bottom and righ peg first, then add the top left one (when you looking from the bottom). The top left is the one that is close to the profile button. This one is a bit smaller than the other ones, so it should have enough margin to fit.

Depending on your printer you might have to send the pegs just a little for it to fit.

For minimal support, just print like picture 2.