Thingiverse
B-daman Bolas Shot
von Studio_Revoct
6
Downloads
4
Likes
0
Makes
A weird strike shot that as usual barely works, but hey it's fun to use.
Print two Center pieces and four Halves, run some twine through the center hole and tie a knot that will stop the twine from slipping out. Once both Centers are tied together glue the two halves together, there should be enough room to slide the holes over the center properly, so it would fit and fire out a b-daman decently.
Print two Center pieces and four Halves, run some twine through the center hole and tie a knot that will stop the twine from slipping out. Once both Centers are tied together glue the two halves together, there should be enough room to slide the holes over the center properly, so it would fit and fire out a b-daman decently.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
