Thingiverse
B9 Creator Vat Dam
von 3dtasmania
10
Downloads
2
Likes
0
Makes
This is a dam to put in the vat of the B9 Creator DLP printer. It allows you to use less PDMS per coating, and achieve a more flat finish.
For more info, check out the following thread on the B9 forums:
http://b9creator.com/support/?mingleforumaction=viewtopic&t=1703
For more info, check out the following thread on the B9 forums:
http://b9creator.com/support/?mingleforumaction=viewtopic&t=1703
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
