Baby Activity Stand

Activity stand for small children, just buy some rings like shown on the picture, and attach some toys to them in the right height for the child.

What you need:

4 x Foot (no supports needed)
4 x Support Connector (no supports needed)
2 x End Connector (use support from plate, since it has a steep overhang)

For the wooden parts, you need to following (all in round wooden sticks - look in your local DIY shop)

4 x 550mm Ø22mm (for the legs)
2 x 300mm Ø13mm (for the supports between the legs)
1 x 600mm Ø22mm (for the connector between the two halves)

To assemble the supports, it is easies to put the 300mm sticks into one of them, and the assemble the other support while sliding it "up" the legs (not easy to explain, it will make sense once you try and assemble it).

Once it has been printed and assembled, take a pencil and mark the holes.
Then disassemble, drill half way through the wooden sticks where you marked, and reassemble.
Finally use some 15x3,5mm screws to s