MakerWorld
Other House Models
Go to Model
Baby Gate Bumper
3
Downloads
1
Likes
1
Makes
I created this model because my baby gate kept sitting against the trim on the wall instead of the actual bumper. You may need to adjust your printing settings but I used 4 walls, 0.16 mm layer height and a 0.4 mm nozzle. You can print this with the hole facing towards the print plate. It was modeled with no overhangs greater than 45 degrees so it should be printable for most materials.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!